First polish, then heat just enough.
 | ||
| First attempt; not great. |
Second attempt was much better
Subscribe to:
Post Comments (Atom)
Bushing an egg-shaped hole without a lathe
This wasn't the smartest idea I've ever had. My 1-jewel Swiss movement had an egg-shaped hole for the barrel arbour in the bridge a...
-
The movement Had this Velona 1100 Compressor with an ETA 2409 that I purchased, it ran but there was way too much play in the barrel. This w... -
Lower quality watches cut costs by reducing the number of jewels in a movement. A 17 jewel movement is considered fully jeweled, 15 jewels... -
This one kinda ran, but only occasionally. Would randomly stop. It uses a pin-pallet escapement (Roskopf) so the 17 jewels on dial, while ...
No comments:
Post a Comment
Note: only a member of this blog may post a comment.